Skip to main content

IS-IS Flooding Speed advertisement
draft-decraene-lsr-isis-flooding-speed-01

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
Authors Bruno Decraene , Chris Bowers , Jayesh , Tony Li , Gunter Van de Velde
Last updated 2020-01-06 (Latest revision 2019-07-05)
Replaced by draft-decraeneginsberg-lsr-isis-fast-flooding
RFC stream (None)
Formats
Additional resources
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document proposes a mechanism that can be used to increase the speed at which link state information is flooded across a network when multiple LSPDUs need to be flooded, such as in case of a node failure. It also reduces the likelihood of overloading the downstream flooding neighbors. This document defines a new TLV to be advertised in IS-IS Hello messages. This TLV carries two parameters indicating the performance capacity to receive LSPDUs: the minimum delay between two consecutive LSPDUs and the number of LSPDUs which can the received back to back.

Authors

Bruno Decraene
Chris Bowers
Jayesh
Tony Li
Gunter Van de Velde

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)