Skip to main content

Using NETCONF over QUIC connection
draft-dai-quic-netconf-03

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Jinyou Dai , Xueshun Wang , Yang Kou , Lifen Zhou
Last updated 2020-10-26
Replaced by draft-dai-netconf-quic-netconf-over-quic
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-dai-netconf-quic-netconf-over-quic
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The Network Configuration Protocol (NETCONF) provides mechanisms to install, manipulate, and delete the configuration of network devices. At present, almost all implementations of NETCONF are based on TCP based protocol. QUIC, a new UDP-based transport protocol, can facilitate to improve the transportation performance, information security and resource utility when being used as an infrastructure layer of NETCONF. This document describes how to use the QUIC protocol as the transport protocol of NETCONF(It is so called NETCONFoQUIC).

Authors

Jinyou Dai
Xueshun Wang
Yang Kou
Lifen Zhou

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)