PCEP Extensions for PCE-initiated LSP Setup in a Stateful PCE Model
draft-crabbe-pce-pce-initiated-lsp-03
| Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
|---|---|---|---|
| Authors | Edward Crabbe , Ina Minei , Siva Sivabalan , Robert Varga | ||
| Last updated | 2014-04-14 (Latest revision 2013-10-11) | ||
| RFC stream | (None) | ||
| Intended RFC status | (None) | ||
| Formats | |||
| Stream | Stream state | (No stream defined) | |
| Consensus boilerplate | Unknown | ||
| RFC Editor Note | (None) | ||
| IESG | IESG state | Expired | |
| Telechat date | (None) | ||
| Responsible AD | (None) | ||
| Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Path Computation Element Communication Protocol (PCEP) provides mechanisms for Path Computation Elements (PCEs) to perform path computations in response to Path Computation Clients (PCCs) requests. The extensions described in [I-D.ietf-pce-stateful-pce] provide stateful control of Multiprotocol Label Switching (MPLS) Traffic Engineering Label Switched Paths (TE LSP) via PCEP, for a model where the PCC delegates control over one or more locally configured LSPs to the PCE. This document describes the creation and deletion of PCE- initiated LSPs under the stateful PCE model.
Authors
Edward Crabbe
Ina Minei
Siva Sivabalan
Robert Varga
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)