RADIUS Extensions for Port Set Configuration and Reporting
draft-cheng-behave-cgn-cfg-radius-ext-04

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Authors Dean Cheng  , Jouni Korhonen  , Mohamed Boucadair 
Last updated 2013-04-19 (latest revision 2012-10-16)
Replaced by draft-cheng-radext-ip-port-radius-ext, RFC 8045, RFC 8045
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Additional Resources
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-cheng-behave-cgn-cfg-radius-ext-04.txt

Abstract

This document defines new RADIUS attributes that can be used by a device implementing port ranges to communicate with a RADIUS server to configure and/or report TCP/UDP port sets and ICMP identifiers mapping behavior for specific hosts. This mechanism can be used in various deployment scenarios such as CGN, NAT64, Provider WiFi Gateway, etc. This document does not make any assumption about the deployment context.

Authors

Dean Cheng (dean.cheng@huawei.com)
Jouni Korhonen (jouni.nospam@gmail.com)
Mohamed Boucadair (mohamed.boucadair@orange.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)