Skip to main content

New Spin bit enabled measurements with one or two more bits
draft-cfb-tsvwg-spinbit-new-measurements-00

Document Type Replaced Internet-Draft (individual)
Expired & archived
Authors Mauro Cociglio , Giuseppe Fioccola , Fabio Bulgarella , Riccardo Sisto
Last updated 2019-11-04
Replaces draft-cfb-ippm-spinbit-new-measurements
Replaced by draft-cfb-ippm-spinbit-measurements
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-cfb-ippm-spinbit-measurements
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This document introduces additional measurements by using the same spin bit signal as defined in [I-D.trammell-tsvwg-spin] and [I-D.trammell-ippm-spin]. The spin bit signal alone is not enough to evaluate correctly in every network condition the RTT of a flow. In order to solve this problem, it is theorized the possibility of introducing an additional validation signal called delay bit, similar to what is done by the Valid Edge Counter (VEC), but using just one bit instead of two. An alternative with two bits is also introduced with a so called loss bit. More in general a loss signal is defined to measure packet loss and two alternatives are presented with one bit and two bits.

Authors

Mauro Cociglio
Giuseppe Fioccola
Fabio Bulgarella
Riccardo Sisto

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)