Preferred Path Loop-Free Alternate (pLFA)
draft-bryant-rtgwg-plfa-00

Document Type Expired Internet-Draft (individual)
Authors Stewart Bryant  , Uma Chunduri  , Toerless Eckert 
Last updated 2020-01-03 (latest revision 2019-07-02)
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bryant-rtgwg-plfa-00.txt

Abstract

Fast re-route (FRR) is a technique that allows productive forwarding to continue in a network after a failure has occurred, but before the network has has time to re-converge. This is achieved by forwarding a packet on an alternate path that will not result in the packet looping. Preferred Path Routing (PPR) provides a method of injecting explicit paths into the routing protocol. The use of PPR to support FRR has a number of advantages. This document describes the advantages of using PPR to provide a loop-free alternate FRR path, and provides a framework for its use in this application.

Authors

Stewart Bryant (stewart.bryant@gmail.com)
Uma Chunduri (uchundur@futurewei.com)
Toerless Eckert (tte+ietf@cs.fau.de)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)