Application of PWE3 to MPLS Transport Networks
draft-bryant-pwe3-mpls-transport-00

Document Type Replaced Internet-Draft (individual)
Last updated 2008-10-27 (latest revision 2006-10-16)
Replaced by draft-ietf-pwe3-mpls-transport
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-ietf-pwe3-mpls-transport
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bryant-pwe3-mpls-transport-00.txt

Abstract

A need has been identified to identify a strict subset of the PWE3 over MPLS pseudowire functionality suitable for the construction of transport networks. This draft describes the IETF recommended profile for such cases. This document describes the IETF-recommended profile for such a configuration. In particular the profile of an RFC4448 PWE3 Ethernet pseudowire that can be used to address these requirements is described.

Authors

Stewart Bryant (stbryant@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)