TRILL using Pseudo-Wire Emulation (PWE) Encapsulation
draft-bryant-perlman-trill-pwe-encap-00

Document Type Expired Internet-Draft (individual)
Last updated 2005-10-19
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-bryant-perlman-trill-pwe-encap-00.txt

Abstract

A new layer of encapsulation is required with RBridges. This layer must contain at least a time-to-live and an RBridge identifier field. This document proposes that the reuse of the encapsulation defined by PWE3 for encapsulation of Ethernet frames over an MPLS packet switched network.

Authors

Stewart Bryant (stbryant@cisco.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)