UPnP IGD-PCP Interworking Function
draft-bpw-softwire-upnp-pcp-interworking-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Mohamed Boucadair , Reinaldo Penno , Dan Wing | ||
Last updated | 2010-10-11 (Latest revision 2010-09-15) | ||
Replaced by | draft-bpw-pcp-upnp-igd-interworking | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-bpw-pcp-upnp-igd-interworking | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies the behavior of the UPnP IGD (Internet Gateway Device)/PCP interworking function. An UPnP IGD-PCP Interworking function is required to be embedded in CP routers to allow for transparent NAT control in environments where UPnP is used in the LAN side and PCP in the external side of the CP router.
Authors
Mohamed Boucadair
Reinaldo Penno
Dan Wing
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)