DHCP Options for Distributed-Denial-of-Service Open Threat Signaling (DOTS)
draft-boucadair-dots-dhcp-01

Document Type Replaced Internet-Draft (individual)
Last updated 2017-04-12
Replaced by draft-boucadair-dots-server-discovery
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Replaced by draft-boucadair-dots-server-discovery
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-boucadair-dots-dhcp-01.txt

Abstract

It may not be possible for a network to determine the cause for an attack, but instead just realize that some resources seem to be under attack. To fill that gap, Distributed-Denial-of-Service Open Threat Signaling (DOTS) allows a network to inform a server that it is under a potential attack so that appropriate mitigation actions are undertaken. This document specifies DHCP (IPv4 and IPv6) options to configure hosts with DOTS servers.

Authors

Mohamed Boucadair (mohamed.boucadair@orange.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)