Skip to main content

Dynamic Host Configuration Protocol (DHCPv6) Options for Shared IP Addresses Solutions
draft-boucadair-dhcpv6-shared-address-option-01

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Mohamed Boucadair , Pierre Levis , Jean-Luc Grimault , Teemu Savolainen , Gabor Bajko
Last updated 2009-12-20
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

This memo defines Dynamic Host Configuration Protocol version 6 (DHCPv6) Options to be used in the context of shared IP address solutions. In some deployment scenarios, DHCP (IPv4) cannot be used to configure customer devices because only IPv6 capabilities are deployed (e.g., DS-lite context or IPv6 Port Range). Therefore, DHCPv6 may be used to convey IPv4-related configuration information such as Port Range and/or Port Extended IPv4 addresses. This document defines also a DHCPv6 Option aiming to convey the IPv6 prefix to be used to build IPv4 Embedded IPv6 addresses [I-D.ietf-behave-address-format].

Authors

Mohamed Boucadair
Pierre Levis
Jean-Luc Grimault
Teemu Savolainen
Gabor Bajko

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)