Delivering MPLS Services Over L3VPN
draft-bonica-mplsvpn-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Kireeti Kompella | ||
Last updated | 2006-06-02 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes procedures that can be used to deliver MPLS services over Layer 3 Virtual Private Networks (L3VPN). Using these procedures, a VPN customer can signal MPLS Label Switched Paths (LSP) from Customer Edge (CE) router to CE router. Although a Service Provider (SP) network carries the Customer LSP (C-LSP) from one CE router to another, the C-LSP does not interact with the SP network's routing or signaling infrastructure.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)