LDP Downstream-on-Demand in Seamless MPLS
draft-beckhaus-ldp-dod-01
Document | Type | Replaced Internet-Draft (individual) | |
---|---|---|---|
Authors | Kishore Tiruveedhula , Luca Martini , Thomas Beckhaus , Bruno Decraene , Maciek Konstantynowicz | ||
Last updated | 2012-01-05 (latest revision 2011-10-31) | ||
Replaced by | RFC 7032 | ||
Stream | (None) | ||
Intended RFC status | (None) | ||
Formats |
Expired & archived
pdf
htmlized (tools)
htmlized
bibtex
|
||
Stream | Stream state | (No stream defined) | |
Consensus Boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-mpls-ldp-dod | |
Telechat date | |||
Responsible AD | (None) | ||
Send notices to | (None) |
https://www.ietf.org/archive/id/draft-beckhaus-ldp-dod-01.txt
Abstract
Seamless MPLS design enables a single IP/MPLS network to scale over core, metro and access parts of a large packet network infrastructure using standardized IP/MPLS protocols. One of the key goals of Seamless MPLS is to meet requirements specific to access, including high number of devices, their position in network topology and their compute and memory constraints that limit the amount of state access devices can hold.This can be achieved with LDP Downstream-on-Demand (LDP DoD) label advertisement. This document describes LDP DoD use cases and lists required LDP DoD procedures in the context of Seamless MPLS design. In addition, a new optional TLV type in the LDP label request message is defined for fast-up convergence.
Authors
Kishore Tiruveedhula
(kishoret@juniper.net)
Luca Martini
(lmartini@cisco.com)
Thomas Beckhaus
(thomas.beckhaus@telekom.de)
Bruno Decraene
(bruno.decraene@orange.com)
Maciek Konstantynowicz
(maciek@juniper.net)
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)