LSP Modification Using CR-LDP
draft-ash-crlsp-modify-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Peter J. Ashwood-Smith , Don Fedyk , Bilel Jamoussi , Bilel Jamoussi , Y Lee , Li Li | ||
Last updated | 1999-06-24 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
After a CR-LSP is set up, its bandwidth reservation may need to be changed by the network operator, due to the new requirements for the traffic carried on that CR-LSP [2]. This contribution presents an approach to modify the bandwidth and possibly other parameters of an established CR-LSP using CR-LDP [3] without service interruption. The LSP modification feature can be supported by CR-LDP with a minor extension of an _action indicator flag_. This feature has application in dynamic network resources management where traffic of different priorities and service classes is involved.
Authors
Peter J. Ashwood-Smith
Don Fedyk
Bilel Jamoussi
Bilel Jamoussi
Y Lee
Li Li
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)