LSP Modification Using CR-LDP
draft-ash-crlsp-modify-00

Document Type Expired Internet-Draft (individual)
Authors Peter Ashwood-Smith  , Don Fedyk  , Bilel Jamoussi  , Bilel Jamoussi  , Y Lee  , Li Li 
Last updated 1999-06-24
Stream (None)
Intended RFC status (None)
Formats
Expired & archived
pdf htmlized (tools) htmlized bibtex
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ash-crlsp-modify-00.txt

Abstract

After a CR-LSP is set up, its bandwidth reservation may need to be changed by the network operator, due to the new requirements for the traffic carried on that CR-LSP [2]. This contribution presents an approach to modify the bandwidth and possibly other parameters of an established CR-LSP using CR-LDP [3] without service interruption. The LSP modification feature can be supported by CR-LDP with a minor extension of an _action indicator flag_. This feature has application in dynamic network resources management where traffic of different priorities and service classes is involved.

Authors

Peter Ashwood-Smith (petera@nortel.ca)
Don Fedyk (dwfedyk@nortel.com)
Bilel Jamoussi (jamoussi@NortelNetworks.com)
Bilel Jamoussi (jamoussi@nortel.ca)
Y Lee (younglee@att.com)
Li Li (lili@nortelnetworks.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)