The Quality for Service Protocol

The information below is for an old version of the document
Document Type Expired Internet-Draft (individual)
Last updated 2018-04-19 (latest revision 2017-07-17)
Stream (None)
Intended RFC status (None)
Expired & archived
plain text pdf html bibtex
IETF conflict review conflict-review-aranda-dispatch-q4s
Additional URLs
Stream Stream state (No stream defined)
Consensus Boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at


This memo describes an application level protocol for the standard communication of e2e QoS compliance information using a protocol based on Hypertext Transfer Protocol (HTTP), which forms the basis for the World Wide Web, and Session Description Protocol (SDP). Quality for Service Protocol (Q4S) provides a mechanism for latency, jitter, bandwidth and packet loss negotiation and monitoring, alerting whenever one of the negotiated conditions is violated. Implementation details on the actions to be triggered upon reception/detection of QoS alerts exchanged by the protocol are out of scope of this draft, it is application dependent (e.g. increase quality, reduce bit-rate) or even network dependent (e.g. change connection's quality profile).


Jose Aranda (
Jacobo Lajo (
Luis Vizcaino (
Gonzalo Fernandez (
Carlos Barcenilla (
Monica Cortes (
Joaquin Salvachua (
Juan Quemada (
Tecnalia Innovation (
Inaki Sarriegui (
Lara Ibanez (
Pablo Zapico (

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)