Skip to main content

MPLS Extension Header Architecture
draft-andersson-mpls-eh-architecture-00

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
Authors Loa Andersson , Jim Guichard , Haoyu Song , Stewart Bryant
Last updated 2019-08-17 (Latest revision 2019-02-13)
Replaced by draft-andersson-mpls-mna-operation-architecture
RFC stream (None)
Formats
Additional resources
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Extension Headers (EH) carry information on in-network services and functions in an MPLS network. This document describes an architecture for EHs and what actions an EH capable Label Switching Router (LSR) takes when finding or not finding an EH in the packet. Multiprotocol Label Switching (MPLS) is a widely deployed forwarding technology. It uses label stack entries that are pre-pended to either the EH or the ACH which in turn is pre-pended to the payload. The label stack entries are used to identify the forwarding actions by each LSR. Actions may include pushing, swapping or popping the labels, and using the labels to determine the next hop for forwarding the packet. Labels may also be used to establish the context under which the packet is forwarded. The extension headers are carried after the MPLS Label Stack, and the presence of EHs are indicated in the label stack by an Extension Header Indicator (EHI).

Authors

Loa Andersson
Jim Guichard
Haoyu Song
Stewart Bryant

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)