DHCPv4 and DHCPv6 options for Access Point Location Information
draft-xue-dhcp-location-option-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Li Xue , Behcet Sarikaya | ||
Last updated | 2013-08-22 (Latest revision 2013-02-18) | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document introduces Control and Provisioning of Wireless Access Points Wireless Termination Point information transported using DHCP. In this procedure, DHCP snooping is deployed on the Wireless Termination Point node or Access Controller node. Then the Wireless Termination Point information can be inserted into the DHCP message in extension option. Because the DHCP messages is send out from the subscriber, so binding between Wireless Termination Point information and subscriber is set up after this procedure. Then Gateway obtains the Wireless Termination Point information through the subscriber access network.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)