Serial forwarding approach to connecting TinyOS-based sensors to IPv6 Internet
draft-sarikaya-6lowpan-forwarding-00
Document | Type |
Expired Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Behcet Sarikaya | ||
Last updated | 2006-02-23 | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes a simple approach to interconnect IEEE 802.15.4 sensor nodes to IPv6 Internet. The technique requires a gateway node that is connected to both the sensor network and the IPv6 Internet. The gateway node runs the serial forwarder over IPv6. Sensor nodes run the open-source TinyOS operating system and generate TinyOS packets. The sensor network can be accessed from IPv6 Internet using a Web interface and the serial forwarder that runs in the applets enables reception/transmission of TinyOS packets over IPv6.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)