Skip to main content

Industrial Routing Requirements in Low Power and Lossy Networks
draft-pister-rl2n-indus-routing-reqs-00

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Kris Pister , Rick Enns , JP Vasseur , Pascal Thubert
Last updated 2007-11-10
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Wireless, low power field devices enable industrial users to significantly increase the amount of information collected and the number of control points that can be remotely managed. The deployment of these wireless devices will significantly improve the productivity and safety of the plants while increasing the efficiency of the plant workers. For wireless devices to have a significant advantage over wired devices in an industrial environment the wireless network needs to have three qualities: low power, high reliability, and easy installation and maintenance. The aim of this document is to analyze the requirements for the routing protocol used for low power and lossy networks (L2N) in industrial environments.

Authors

Kris Pister
Rick Enns
JP Vasseur
Pascal Thubert

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)