Skip to main content

Path Computation Element (PCE) Protocol Extensions for Stateful PCE usage for Point-to-Multipoint Traffic Engineering Label Switched Paths
draft-palle-pce-stateful-pce-p2mp-05

The information below is for an old version of the document.
Document Type
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
Authors Udayasree Palle , Dhruv Dhody , Yosuke Tanaka , Yuji Kamite , Zafar Ali , Vishnu Pavan Beeram
Last updated 2015-04-13 (Latest revision 2014-10-10)
Replaced by draft-ietf-pce-stateful-pce-p2mp, RFC 8623
RFC stream (None)
Formats
Additional resources
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

The Path Computation Element (PCE) has been identified as an appropriate technology for the determination of the paths of point- to-multipoint (P2MP) TE LSPs. This document provides extensions required for PCEP so as to enable the usage of a stateful PCE capability in supporting point-to-multipoint (P2MP) TE LSPs.

Authors

Udayasree Palle
Dhruv Dhody
Yosuke Tanaka
Yuji Kamite
Zafar Ali
Vishnu Pavan Beeram

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)