BFD for Multipoint Networks over Point-to-Multi-Point MPLS LSP
draft-mirsky-mpls-p2mp-bfd-03
Document | Type |
This is an older version of an Internet-Draft whose latest revision state is "Replaced".
Expired & archived
|
|
---|---|---|---|
Author | Greg Mirsky | ||
Last updated | 2018-08-19 (Latest revision 2018-02-15) | ||
Replaced by | draft-ietf-mpls-p2mp-bfd | ||
RFC stream | (None) | ||
Formats | |||
Additional resources | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Expired | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document describes procedures for using Bidirectional Forwarding Detection (BFD) for multipoint networks to detect data plane failures in Multiprotocol Label Switching (MPLS) point-to-multipoint (p2mp) Label Switched Paths (LSPs). It also describes applicability of out- band solutions to bootstrap a BFD session in this environment.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)