Diameter Load Information Conveyance
draft-ietf-dime-load-02

The information below is for an old version of the document
Document Type Expired Internet-Draft (dime WG)
Last updated 2016-09-19 (latest revision 2016-03-18)
Stream IETF
Intended RFC status (None)
Formats
Expired & archived
plain text pdf html bibtex
Additional URLs
- Mailing list discussion
Stream WG state Waiting for WG Chair Go-Ahead (wg milestone: Mar 2015 - Submit a document on... )
Revised I-D Needed - Issue raised by WGLC, Other - see Comment Log
Document shepherd No shepherd assigned
IESG IESG state Expired
Consensus Boilerplate Unknown
Telechat date
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft can be found at
https://www.ietf.org/archive/id/draft-ietf-dime-load-02.txt

Abstract

This document defines a mechanism for sharing of Diameter load information. [RFC7068] describes requirements for Overload Control in Diameter. This includes a requirement to allow Diameter nodes to send "load" information, even when the node is not overloaded. The Diameter Overload Information Conveyance (DOIC) [RFC7683] solution describes a mechanism meeting most of the requirements, but does not currently include the ability to send load information.

Authors

Ben Campbell (ben@nostrum.com)
Steve Donovan (srdonovan@usdonovans.com)
Jean-Jacques Trottin (jean-jacques.trottin@nokia.com)

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)