Skip to main content

Use Cases for an Interface to MPLS TE
draft-huang-i2rs-mpls-te-usecases-02

Document Type Expired Internet-Draft (individual)
Expired & archived
Authors Tieying Huang, Zhenbin Li , Susan Hares
Last updated 2015-01-05 (Latest revision 2014-07-04)
RFC stream (None)
Intended RFC status (None)
Formats
Stream Stream state (No stream defined)
Consensus boilerplate Unknown
RFC Editor Note (None)
IESG IESG state Expired
Telechat date (None)
Responsible AD (None)
Send notices to (None)

This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:

Abstract

Network services based on Virtual Networks (VN) or Virtual Circuits (VC) may be run over MPLS-TE links, and support network configurations such as hub-spoke, service routing, or on-demand networks. An MPLS Traffic Engineering(TE) network is typically configured and the results of its operation analyzed through network management interfaces (CLI, SNMP or NETCONF). These interactions control each of the MPLS TE links, and diagnose operations issues concerning link configuration, MPLS TE protection, and traffic switching-over. The network management functions also monitor MPLS TE links and provide fault detection. The Interface to the Routing System (I2RS) (draft-ietf-i2rs- architecture) programmatic interface to the routing system provides an alternative way to control the configuration and diagnose the operation of MPLS links. I2RS may be used for the configuration, manipulation, polling, or analyzing MPLS TE. This document describes a set of use cases for which I2RS can be used for MPLS TE. It is intended to provide a base for a solution draft describing I2RS information models and protocol functions that will support virtual networks that utilize MPLS TE.

Authors

Tieying Huang
Zhenbin Li
Susan Hares

(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)