Diameter Applications Design Guidelines
draft-fajardo-dime-app-design-guide-02
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Victor Fajardo | ||
Last updated | 2010-04-12 (Latest revision 2007-04-18) | ||
Replaced by | draft-ietf-dime-app-design-guide | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-dime-app-design-guide | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
The Diameter Base protocol provides rules on how to extend Diameter and to create new Diameter applications. This is a companion document to clarify these rules. This document does not intended to add, remove or change these rules, rather it helps protocol designers to extend Diameter.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)