DHCP and DHCPv6 Options for the Port Control Protocol (PCP)
draft-bpw-pcp-dhcp-04
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Authors | Mohamed Boucadair , Reinaldo Penno , Dan Wing | ||
Last updated | 2011-04-27 | ||
Replaces | draft-bpw-softwire-pcp-dhcp | ||
Replaced by | draft-ietf-pcp-dhcp | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-pcp-dhcp | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
This document specifies DHCP (IPv4 and IPv6) options to configure hosts with Port Control Protocol (PCP) Server addresses. The use of IPv4 DHCP or DHCPv6 depends on the PCP deployment scenario.
Authors
Mohamed Boucadair
Reinaldo Penno
Dan Wing
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)