Flow Identity Extension for HELD
draft-bellis-geopriv-flow-identity-01
Document | Type |
Replaced Internet-Draft
(individual)
Expired & archived
|
|
---|---|---|---|
Author | Ray Bellis | ||
Last updated | 2012-11-05 (Latest revision 2012-05-14) | ||
Replaced by | draft-ietf-geopriv-flow-identity | ||
RFC stream | (None) | ||
Intended RFC status | (None) | ||
Formats | |||
Stream | Stream state | (No stream defined) | |
Consensus boilerplate | Unknown | ||
RFC Editor Note | (None) | ||
IESG | IESG state | Replaced by draft-ietf-geopriv-flow-identity | |
Telechat date | (None) | ||
Responsible AD | (None) | ||
Send notices to | (None) |
This Internet-Draft is no longer active. A copy of the expired Internet-Draft is available in these formats:
Abstract
Identity Extensions using an IP address and port number to request a location based on an individual packet flow have been previously specified by the GEOPRIV Working Group. However certain kinds of NAT require that identifiers for both ends of the packet flow must be specified in order to unambiguously satisfy the location request. This document specifieds a Flow Identity Extension for the HTTP- Enabled Location Delivery (HELD) Protocol to support this requirement.
Authors
(Note: The e-mail addresses provided for the authors of this Internet-Draft may no longer be valid.)